:: OIL CHILLERS  

Process oil used for applications such as hydraulics, cutting, lubrication, broaching, honing, quenching, etc., also aid as a cooling media in other words, the heat dissipated during the process is carried away by the circulating oil, now this oil needs to be maintained at a certain temperature range to retain its physical and chemical properties. Our oil chillers adapt the most proven design to suit specific application. Where the direct oil cooling is not advised we applied secondary system in water acts as the secondary refrigerant

Oil chillers are available in configuration like stand alone in which the oil recirculating pump in built and immersion type in which the evaporator coil is dipped directly in the oil sump and indirect type in which the oil will be cooled in PHE with water as a secondary refrigerant.

 

CAPACITY RANGE

0.5 TR – 100 TR and above

UNIT TYPE

Independent function or group function

TEMPERATURE

+ 20˚C TO + 30˚C Media Temperature

COOLING CAPACITY

Evaporation at 7˚C, Condensation at 50˚C

COOLING MEDIA

Water, oil

EVAPORATION TYPE

Online, storage type, direct immersion Type and indirect type secondary

COMPRESSOR TYPE

Hermatically sealed, semi hermatic, screw, Open type

CONDENSORS

Water or air cooled grooved pipe heat exchanger

EVAPORATOR

Plate type heat exchanger, fin and tube Type, shell and tube type, dipped coil And tube in tube type
 

WATER FLOW RATE

Very wide range from 5 Lpm to 200 Lpm +

WATER PUMP

Centrifugal monobloc, gear pump, vertical Multi stage pump, piston pump (optional) Stainless steel pumps

REFRIGERANT TYPE

R- 22 , R-134A, R-404A, R-507A, R-407C

INSULATION

Torcellin, puf, nitral rubber, thermocool,thermorex

ELECTRICALS

1 Ph – 230 V, 50 Hz, AC,  3 Ph – 440 V, 50 Hz, AC, Attachable, Detachable Panel Board

WORLDCLASS

Designed to meet ASHRAE, ARI and International standards
 

 
 
   Ccopy Rights Scan Air all rights reserved